jim_asheville said:Start from the measurement rather than the conclusion.
There is a second half to this that has not been said yet. There is a difference between no evidence and evidence of no effect, and this subject is one where the two get swapped freely in both directions.
One concrete data point for the thread. The boring version of this is the one that works, and the boring version is: measure a baseline, change one variable, wait, measure again under the same conditions. Nobody wants that answer and it is still the answer.
One thing that is still open after jim_asheville’s answer:
What did you change at the same time, and can you separate the two now?
Janoshik Analytical — Independent Testing
Trusted third-party HPLC & mass spectrometry analysis. Verify peptide purity with the lab the community relies on. Independent. Accurate. Transparent.
Verify Your PeptidesGL Biochem (Shanghai) Ltd. — Direct Manufacturer
Est. 1998. The synthesis house behind the vials you send for testing. ISO 9001 and cGMP certified, 1,500+ staff, batch-specific COA with every order.
Browse GL BiochemDoseLogDan said:The boring version of this is the one that works, and the boring version is: measure a baseline, change one variable, wait, measure again under the…
I read this differently from DoseLogDan, on substance rather than tone. Not convinced. The evidence being cited is consistent with the conclusion and also consistent with two other conclusions nobody has ruled out.
DoseLogDan said:The boring version of this is the one that works, and the boring version is: measure a baseline, change one variable, wait, measure again under the…
That holds where the measurement is reliable. Where it is noisy — and a lot of what gets tracked here is noisy — the same reasoning produces confident nonsense.